Honest, locally-anchored pricing for washer, dryer, refrigerator, dishwasher, oven, and garburator repair across Coquitlam, Port Coquitlam, Port Moody, and Maple Ridge. All prices include parts & labour. $89 diagnostic — waived when you book the repair.
Below are the typical repair ranges we quote across the Tri-Cities in 2026, based on hundreds of real service calls in Coquitlam, Port Coquitlam, Port Moody, and Maple Ridge. Final price depends on the specific make, age, and part availability — but the ranges below cover ~85% of real jobs.
Every job starts with a $89 flat-rate diagnostic. If you proceed with the repair, the diagnostic fee is credited toward the total. Every repair is covered by our 3-month warranty on parts and labour.
Prices below include parts + labour + travel within our standard Tri-Cities service area. We don't charge separate trip fees inside Coquitlam, Port Coquitlam, Port Moody, or Maple Ridge. For Burnaby, Pitt Meadows, Anmore, or Belcarra a small travel charge may apply — quoted upfront before any work begins.
| Repair | Typical Range | What's Included |
|---|---|---|
| Drain pump replacement | $180–$260 | Pump, gaskets, labour, 3-mo warranty |
| Lid-lock / door-lock fix | $140–$200 | Switch assembly, harness, labour |
| Drive belt or motor coupling | $160–$240 | Belt/coupling, labour |
| Tub seal & bearing | $280–$420 | Full tear-down job, parts, labour |
| Control board / main board | $290–$440 | OEM board, diagnostic, install |
| Water inlet valve | $150–$220 | Valve, gaskets, labour |
| Suspension rods / shocks | $200–$300 | All 4 rods, labour, balance check |
| Repair | Typical Range | What's Included |
|---|---|---|
| Heating element replacement | $180–$280 | Element, thermal fuse check, labour |
| Thermal fuse / thermostat | $120–$180 | Both parts replaced, vent check |
| Drum belt + idler pulley | $140–$200 | Belt, pulley, labour |
| Drum rollers / bearings | $180–$260 | Full roller set, labour |
| Igniter (gas dryer) | $160–$230 | Igniter, gas-valve check |
| Moisture sensor calibration | $130–$190 | Sensor cleaning + recalibration |
| Control board replacement | $260–$380 | OEM board, install |
| Repair | Typical Range | What's Included |
|---|---|---|
| Start relay / capacitor | $150–$220 | Relay, capacitor, diagnostic |
| Evaporator / condenser fan motor | $200–$300 | Motor, blade, labour |
| Defrost system (board, heater, thermistor) | $220–$340 | Whichever component failed, labour |
| Door gasket replacement | $160–$260 | Gasket, seal-check, labour |
| Ice maker module | $240–$360 | Module, water line check |
| Compressor replacement (sealed system) | $650–$1,100 | Referred to licensed gas-handler partner |
| Water inlet valve / filter housing | $180–$280 | Valve, housing, labour |
| Repair | Typical Range | What's Included |
|---|---|---|
| Drain pump replacement | $170–$240 | Pump, gaskets, labour |
| Heating element | $180–$260 | Element, thermistor check |
| Door latch / thermal fuse | $140–$200 | Latch assembly, fuse |
| Door gasket / hose leak repair | $160–$240 | Gasket, hose, labour |
| Spray arm or impeller | $140–$220 | Part, descaling, labour |
| Control board replacement | $240–$360 | OEM board, install |
| Bosch / Miele specialist diagnostic | +$30 | Premium-brand error-code lookup |
| Repair | Typical Range | What's Included |
|---|---|---|
| Bake element replacement | $150–$220 | Element, install |
| Igniter (gas oven) | $160–$230 | Igniter, gas-valve check |
| Oven temperature sensor | $140–$200 | Sensor, recalibration |
| Door hinge or spring | $180–$280 | Hinges/springs, seal check |
| Surface burner / spark module | $160–$240 | Burner, module, labour |
| Convection fan motor | $220–$320 | Motor, balance, labour |
| Control board / touch panel | $280–$440 | OEM board, install |
| Premium ranges (Bertazzoni, Wolf, Dacor) | +$40–$80 | OEM-only parts surcharge |
| Repair | Typical Range | What's Included |
|---|---|---|
| Jam clearing & reset | $80–$120 | Clear jam, reset, test cycle |
| Seal or flange leak repair | $90–$160 | Seal, plumber's putty, labour |
| Switch or wiring repair | $100–$160 | Switch, wire repair, labour |
| Motor replacement | $130–$200 | Motor, install, test |
| New unit + installation | $200–$350 | Unit (InSinkErator/Waste King) + install |
| Premium ¾–1 HP unit + install | $320–$520 | Higher-grade unit + install |
| Repair | Typical Range | What's Included |
|---|---|---|
| Washer pump or thermal fuse | $160–$220 | Part, labour |
| Dryer heating element | $180–$260 | Element, labour |
| Drive belt or motor coupling | $180–$240 | Part, labour |
| Drum bearing / roller | $240–$340 | Tear-down job, labour |
| Control board replacement | $240–$320 | OEM board, install |
Most repairs in Coquitlam, Port Coquitlam, Port Moody, and Maple Ridge fall in the $140–$320 range — covering common faults like drain pumps, heating elements, control boards, and door issues. The diagnostic visit itself is a flat $89, which is credited toward your total if you approve the repair. Premium-brand parts (Bertazzoni, Wolf, Miele) typically add $30–$80.
The $89 diagnostic fee is fully credited toward the repair total when you book the repair with us. If you decide not to proceed, the diagnostic fee covers the technician's time. There are no hidden trip charges inside our core Tri-Cities service area.
Every repair is backed by our 3-month warranty on parts and labour. If the same fault recurs within 90 days, we come back and re-fix it free of charge. Parts replaced with OEM components carry the manufacturer's parts warranty in addition.
Rule of thumb: if the repair cost is under 50% of replacement cost and the appliance is under 8 years old, repair almost always wins. Past 12 years and over 60% of replacement cost, replacement becomes the smarter call. Our diagnostic includes an honest recommendation based on the specific make, age, and what we find — no upsell pressure.
No surcharge for same-week service. Same-day visits (when route availability allows) are at standard rates. After-hours emergency calls (evenings, statutory holidays) may carry a $40 dispatch surcharge — quoted upfront.
Sealed-system refrigerant work (compressor regassing) is the only category we don't perform in-house — we refer to a licensed gas-handler partner for that, typically $650–$1,100 for a full compressor + regas. Everything else listed above is start-to-finish in-house.
The ranges above cover most jobs. For the exact number — and to start the repair the same visit — book your $89 diagnostic now.